fbpx

Loop HLS Recording SDI/IP

dt logo 1.5inchNet-X-Code supports loop recording of multi bitrate HLS streams from IP or SDI sources.  Setting this up requires configuration of the capture component and of the HLS adaptive bitrate settings.  This article covers the SDI and IP capture.  For the ABR setup, see https://www.drastic.tv/support-59/supporttipstechnical/303-multirate-hls-dash-setup

 

 SDI Setup

To record from SDI, go to the SDI configuration page on the web or in DDRConfig and select "ts-hls" as the record type.  After setting up your input signal format and audio settings, set up the adaptive bit rates here:

https://www.drastic.tv/support-59/supporttipstechnical/303-multirate-hls-dash-setup

IP Setup

To set up an IP record, set up the multicase, port and IP type normally.  For record type, select "ts-hls".   For windows, this will be in the registry (please note, if running as a service it will be under HKEY_LOCAL_MACHINE instead of HKEY_CURRENT_USER):

Computer\HKEY_CURRENT_USER\Software\Drastic\NetXCmd\Groups\NetXCode000\Channel0

RegEdit ts hls Type

For linux, this is stored in ~/.config/Drastic in the NetXCmd.conf file.

 After setting up your input signal format and audio settings, set up the adaptive bit rates here:

https://www.drastic.tv/support-59/supporttipstechnical/303-multirate-hls-dash-setup